• Analisis Keberlanjutan Pemanfaatan Program Penyediaan Air Minum dan Sanitasi Berbasis Masyarakat di Desa Binjai Baru Kecamatan Datuk Tanah Datar Kabupaten Batu Bara 

  Hasbi, Mhd Taufik (Universitas Sumatera Utara, 2025)

  The Community-Based Drinking Water and Sanitation Supply Program (PAMSIMAS) is one of the government’s efforts to improve access to clean water and sanitation in rural areas. However, the sustainability of drinking water ...

• Rancangan Manajemen Tempat Pengolahan Sampah (TPST) di Universitas Sumatera Utara dengan Prinsip Ekonomi Sirkular 

  Pasaribu, Muhammad Jefrizal (Universitas Sumatera Utara, 2025)

  An Integrated Waste Processing Facility (IWPF) is a location where activities such as waste collection, sorting, reuse, processing, and further processing or final processing of waste are carried out. This further ...

• Analisis Daya Dukung Aksial Spun Pile Diameter 60 Cm Menggunakan Uji Beban Statik dan Pemodelan Elemen Hingga (Plaxis 3d) Berdasarkan Data Bh-2 Pada Proyek Gedung Rawat Inap Tower-1 Rs Haji Medan 

  Kaisar, Mochammad Val (Universitas Sumatera Utara, 2025)

  Spun Pile foundations are the primary solution for the construction of multi story buildings in areas with unfavorable soil conditions, such as in the city of Medan. This study analyzes the axial bearing capacity and ...

• Analisa Kinerja Sistem Distribusi Air Bersih PDAM Tirtanadi pada SPAM Offtaker Sumarsono Daerah Pelayanan Sei Agul dan Diski Kecamatan Medan Helvetia 

  Purba, Jonny Hasael (Universitas Sumatera Utara, 2025)

  The clean water distribution system aims to provide and distribute clean water to customers. The problems of clean water provision in Medan Helvetia District which is served by PDAM Tirtanadi Sei Agul-Diski Branch are ...

• Analisis Daya Dukung Pondasi Tiang Pancang Diameter 0,6 Meter dengan Metode Analitis dan Metode Elemen Hingga pada Bore Hole 48R(Studi Kasus Proyek Pembangunan Jalan Tol Ruas Binjai – Langsa,Seksi Binjai – Pangkalan Brandan) 

  Julyta, Naomy (Universitas Sumatera Utara, 2025)

  The foundation is the lowest part of a building's structure and plays a critical role in supporting the entire load of the building and other imposed loads, transferring them down to a firm soil stratum. To ensure a structure ...

• Perencanaan Dinding Penahan Tipe Kantilever Alternatif 2 Tinggi 6 Meter sebagai Penanggulangan Kelongsoran dengan Metode Analitis dan Program Plaxis 2D (Studi Kasus: Perkebunan Nusantara, Sumatera Utara) 

  Nabilah, Nadhifta (Universitas Sumatera Utara, 2025)

  The occurrence of slope failure at the loading ramp station of the palm oil mill owned by Perkebunan Nusantara has disrupted the smooth operation of the production process. This problem arises from its location on a steep ...

• Analisis Tingkat Risiko Bencana Tanah Longsor Berbasis Sistem Informasi Geografis (Sig) di Kecamatan Munte, Kabupaten Karo 

  Banurea, Fauzi Akmal Hadi (Universitas Sumatera Utara, 2025)

  This study aims to analyze the landslide risk level in Munte District, Karo Regency, North Sumatra Province, using a Geographic Information System (GIS) approach. The parameters used include slope gradient, soil type, rock ...

• Analisis Tingkat Risiko Bencana Tanah Longsor Berbasis Sistem Informasi Geografis (Studi Kasus : Kecamatan Kutabuluh, Kabupaten Karo) 

  Attalariqsyah, Attalariqsyah (Universitas Sumatera Utara, 2025)

  Landslides are a common natural disaster in Indonesia, particularly in areas with steep topography and high rainfall, such as Kutabuluh District, Karo Regency. This study aims to analyze the level of landslide risk using ...

• Kajian Bahaya Kekeringan di Kabupaten Langkat Berbasis Sistem Informasi Geografis 

  Sihombing, Paul Thimoty (Universitas Sumatera Utara, 2025)

  Drought is the relationship between the availability of water that is far below the need for water both for life, agriculture, economic activities and the environment, Langkat Regency is one of the districts in North Sumatra ...

• Perbandingan Quantity Take Off pada Suatu Proyek Menggunakan Aplikasi Graphisoft Archicad dan Autodesk Revit 

  Sianturi, Juan Gabriel Albertino (Universitas Sumatera Utara, 2025)

  The Quantity Take-Off (QTO) calculation is one of the crucial stages in construction project planning, as it affects cost estimation, project duration, and material usage efficiency. Errors in QTO can lead to waste, delays, ...

• Kajian Tingkat Bahaya Erosi pada Daerah Aliran Sungai (DAS) Besitang, Kabupaten Langkat 

  Riyadi, Bagus (Universitas Sumatera Utara, 2025)

  Erosion is one of the problems that must be taken seriously in a watershed ecosystem.Besitang watershed is a watershed that requires special attention, especially the Besitang watershed because there is damage that ...

• Analisis Perbandingan Hasil Bill of Quantity (Boq) dengan Software Revit, Tekla Structures dan Excel pada Proyek Pembangunan Fat Trap Refinery II Sei Mangkei 

  Andreas, Luviko Jose (Universitas Sumatera Utara, 2025)

  This study aims to compare the results of Bill of Quantity (BOQ) calculations using three different approaches: Microsoft Excel, Autodesk Revit, and Tekla Structures, applied to the Fat Trap Refinery II Sei Mangkei ...

• Pengaruh Penggunaan Larutan Asam Sulfat Terhadap Kuat Tekan, Tarik Belah Dan Keausan Agregat Kasar Pada Pervious Concrete Sebagai Cover U-Ditch 

  Peterson, Dean (Universitas Sumatera Utara, 2025)

  The rapid development of urban areas has reduced water-absorbing land, leading to water stagnation and flooding. One innovative solution is the use of pervious concrete as a u-ditch cover to enhance water infiltration. ...

• Analisis Kuat Tekan dan Durabilitas Mortar Geopolimer Self-Healing terhadap Perendaman Asam Sulfat (H₂SO₄) 5% dengan Variasi Molaritas 

  Sembiring, Doaldus Rivaldo (Universitas Sumatera Utara, 2025)

  The rapid development of infrastructure in Indonesia requires repair materials with high resistance to aggressive environments. Conventional cement-based materials are known to be vulnerable to deterioration when exposed ...

• Analisis Kinerja Sambungan Extended End Plate pada Bangunan Nitrile Workshop Menggunakan Perhitungan Manual dan Idea Statica 

  Ignacio, Juan Carlo (Universitas Sumatera Utara, 2025)

  Indonesia as a country with high seismic activity requires the planning of building structures that are able to withstand lateral forces due to earthquakes. One of the important components in a steel moment bearing frame ...

• Evaluasi Kapasitas Penampang Sungai Bingei Kota Binjai terhadap Debit Banjir Menggunakan HEC-RAS 

  Silalahi, Ridho Mustafa (Universitas Sumatera Utara, 2025)

  Flooding is a natural disaster that significantly affects human life. Floods can be caused by both natural factors and human activities. This study aims to evaluate the cross-sectional capacity of the Bingei River and to ...

• Penerapan Rekayasa Nilai pada Proyek Konstruksi (Studi Kasus : Proyek Pembangunan Poli Rawat Jalan RSUD Kabupaten Karo) 

  Lumban Gaol, Josep Andre Kresyo (Universitas Sumatera Utara, 2025)

  In construction projects, it is common to find work elements with high costs that can actually be optimized without reducing the function or quality of the building. One systematic approach used to achieve cost efficiency ...

• Pengaruh Ground Granulated Blast Furnace Slag dan Corn Cob Ash sebagai Substitusi Semen terhadap Kuat Tekan High Strength Self Compacting Concrete 

  Tarigan, Calvin Orlando (2025)

  The use of cement replacement materials in the construction industry has become an increasingly important topic in efforts to reduce carbon emissions and support sustainable development. Corn Cob Ash (CCA) and Ground ...

• Analisis Perilaku Struktural pada Balok Beton Bertulang dengan Perkuatan Bio Serat ECC dan Bio Textile ECC Berdasarkan Finite Element Modeling (FEM) 

  Nasution, Haris Fadhillah (Universitas Sumatera Utara, 2025)

  This research aims to validate finite element modeling (FEM) with laboratory experimental results of reinforced concrete beams strengthened with bio-fiber ECC and bio-textile ECC, based on their load–deflection behavior. ...

• Analisis Kinerja Panel Zone pada Desain Struktur Baja dengan Sistem Rangka Pemikul Momen Khusus menggunakan Software ETABS 

  Sihotang, Dian Azra (Universitas Sumatera Utara, 2025)

  Steel structures are the primary choice in the construction of high-rise buildings and modern infrastructure due to their strength, load-bearing capacity, and design flexibility. This study aims to determine the ...

View more